Dynalco Home > Products > Monitoring Solutions > Dynalco

Dynalco Speed Switches



Dynalco speed switches and Dynalco transmitters are reliable, rugged products and come in a variety of configurations. Applications for Dynalco speed switches include under and over-speed controls for engines, turbines, compressors, generator sets, turbochargers and pumps.

Dynalco

SST-2000A

Over/under speed protection, transmitter with 0 relay setpoints, CSA General Classification S The Dynalco SST-2000A has 0 relay setpoints and receives signal input from a passive or active magnetic pickup, shaft encoder, contact closure, flowmeter, etc. to provide proportional analog outputs. Approvals: ABS type, CSA General Classification, and CE approved.



SST-2200A

The Dynalco SST-2200A has 2 relay setpoints and receives signal input from a passive or active magnetic pickup, shaft encoder, contact closure, flowmeter, etc. to provide proportional analog outputs. Approvals: ABS type, CSA, CE approved.



SST-2400A

The Dynalco SST-2400A has 4 relay setpoints and receives signal input from a passive or active magnetic pickup, shaft encoder, contact closure, flowmeter, etc. to provide proportional analog outputs. Approvals: ABS type, CSA General Classification, and CE approved.



SST-2000H

The Dynalco SST-2000H has 0 relay setpoints and receives signal input from a passive or active magnetic pickup, shaft encoder, contact closure, flowmeter, etc. to provide proportional analog outputs. Approvals: ABS type, CSA and CE approved.



SST-2200H

The Dynalco SST-2200H has 0 relay setpoints and receives signal input from a passive or active magnetic pickup, shaft encoder, contact closure, flowmeter, etc. to provide proportional analog outputs. Approvals: ABS type, CSA and CE approved.



SST-2400H

The Dynalco SST-2400H has 4 sealed relay setpoints and receives signal input from a passive or active magnetic pickup, shaft encoder, contact closure, flowmeter, etc. to provide proportional analog outputs. Approvals: ABS type, CSA and CE approved.



SW-200B

The Dynalco SW-200B provides reliable engine overspeed protection. It has three adjustable relay setpoints: number one is overspeed. Uses for the two auxiliaries include crank disconnect, generator field-flashing, and speed monitoring. Setpoints are field-programmable and can be tested without overspeeding. Housing is gasketed and sealed.



SW-50

The Dynalco SW-50 provides reliable engine overspeed protection and is fully field- programmable. It has two relay setpoints: one overspeed plus one auxiliary for crank disconnect, generator field-flashing, or other alarm.



PNT-202

Used In Connection With The SPV-200 Solenoid Pneumatic Valve When the present setpoint overspeed is reached, the Dynalco PNT-202 trips the SPV-200 Solenoid Pneumatic Valve. The valve opens, latches, bleeds to the atmosphere and shuts down the engine if it is connected to the engine pneumatic control system. The PNT-202 also effects shutdown when one of the pickup signals disappears or when an attempt is made to start up with only one operational pickup. The second setpoint can trip the same valve or a separate valve. It can be field programmed as an underspeed setpoint, or as a second overspeed setpoint, or crank disconnect. When set for underspeed, no inhibit is necessary on startup as this setpoint becomes enabled only when the speed exceeds the setpoint.